Parafield Gardens | Salisbury
By apcadmin |

Once your pavers have been laid, here are a few tips to keeping your new addition looking like the day it went down

1. Cleaning

Washing down the pavers with a hose or a high pressure domestic cleaner is not recommended until the pavers have settled and the grout sand has set between the paving joints. The best type of sand to use between the joints is a dried sand or a polymeric sand best known as Paveset or similar. This is sold at most of the Australian Paving Centre stores.
During the settling in period sweep only with a stiff outdoor broom or use a garden blower. When using the blower don’t blow it straight in to the paving joints, use it at an angle so as to not blow any joint sand out.
Frequent sweeping and occasional washing reduces the effect of dirt and grime and maintains the attractiveness of a paved area.

2. General Maintenance

During the initial settling in period & ongoing, keep a bag of dried sand or polymeric sand on hand, to top up any paving joints that may need a little extra between the joints.
When you poison the weeds in the garden do the same to any weeds in the paving. The polymeric sand is better, to stop weed growth.
Poison any paving areas that do not get a lot of sunlight or are prone to be moist, damp or cold as these areas tend to promote the growth of fungus & mold.
If you are pulling any weeds out of the pavers try to get to them before they grow too big. If they are allowed to grow too large as you pull them out it will take the gap sand with the root system.
Preventative spot spraying of the pavers, whilst you are doing the garden is the best way to keep the paving free of weeds.
Tip; when doing the pavers & you have a garden wall or retaining wall, spray the face of the blocks every now and then to prevent mold or fungal growth.
After the pavers have been down for some time, there is nothing wrong with giving them a pressure clean every now & then. DO NOT use a commercial pressure cleaner as this may pit the surface of the pavers, dependent upon the type of paver they are. Use a domestic pressure cleaner of about 1500 psi or less.
If you do pressure clean the paving you must top up the sand in the joints. When using a polymeric sand such as Paveset, read the instructions on how to apply it. Do not over fill the joints when using this type of joint sand. APC have a separate DIY Paving document which explains how to apply this type of joint sand.

3. Tips to Maintaining Your Pavers

  • Do not allow moss, weeds or algae to develop on the paved surfaces. It is important to keep driveway surfaces clean and clear. Use standard pesticides on these surfaces.
  • Regularly sweep or clean the pavers with a stiff outdoor broom or garden blower
  • Occasionally pressure clean your driveway to remove stubborn dirt
  • Top up the joint sand when required
  • Always maintain good drainage away from the paving & ensure your storm water drains are clean & running water freely away from the paved area.

Download PDF